FM AntennaAM AntennaCD PLAYER
L R Optical Coax
AUDIO RECORDER
Figure 4 � Audio Connections
Dashed lines (����) indicate coax and optical
REC/INdigital audio connections. Choose either type
(but not both) for each digital audio source.
PLAY/OUT
Step 4. Connect AM and FM antennas (Fig. 4) (see page 15).your Video Monitor (TV). Switch your TV setOs input to match the typeStep 9. Configure speakers: No action is needed if you have five Osmall�
Step 5. Connect source components, as shown in Figures 4 and 5, and theof video used for the currently selected source.satellite-type speakers and a subwoofer. Otherwise, press the Speaker
Device Connection Options chart on the back of this guide (seeStep 6. Plug all components into AC power outlets. The outlets on the backbutton and then the Set and arrow buttons to select the correct
pages 15�16).of the AVR 325 should be used only for low-current products, suchspeaker choices for your system (see pages 21�23).
AUDIO connections: Right channel (red) on source to right (red) as CD or DVD players, and the total should not exceed 100 watts.Step 10. Use EzSeta to set output levels: Set the Balance to 12 oOclock,
on AVR, and left channel (white) on source to left (white) on AVR.Basic Receiver Configurationand the Volume to �10dB. Sit in the listening position and hold the
DIGITAL AUDIO connections, if available: Choose either coaxStep 7. Select digital inputs: If your DVD is connected to Coax 1, no adjust-remote in front of you at shoulder level, pointing at the AVR 325.
(orange) to coax (orange) OR optical to optical for each device.ment is needed. For any other digital-device connections, use thePress the SPL button for 3 seconds, and release it when the LED
The Coax 1 input defaults to the DVD player, but may be reassigned.front-panel Digital Select button and the arrow buttons to select anflashes amber. Press O5� or O7� to indicate the number of speakers.
Assign the other digital inputs and outputs as appropriate for youroptical or coax digital input (see pages 20 and 27).Hold the remote steady until the process is completed (see pages
equipment (see Step 7).Step 8. Select a surround mode: Press the Surround Mode button on the24�25).
VIDEO connections: Choose component (Y/Pb/Pr � green/blue/front panel to select Dolby¨ Pro Logic¨ II � Movie. (You may selectStep 11. Your system is configured � sit back and enjoy!
red), composite (yellow) or S-Video (4-pin) for each video source.other modes later as you become familiar with the AVR 325; see
Connect the component, composite and S-Video Monitor outputs topages 20�21 and 26�29.)
SPEAKER AND AUDIO CONNECTIONS |